In the first post in this series I wrote a little introduction to Graduated Neutral Density filters what they do and how they look like. In this post, I’m going to show you what you actually will need in order to use them.
My biggest confusion when ordering my first filter set, was, what I would actually need, or what I will get and/or how it looks like. So here I have put together what all is necessary hoping to make it a little easier for others.
What do you need?
The filter set consists of three parts:
a) The filter holder:
This filter holder is equipped with filter slots for two filters.
b) The adaptor ring:
The wide angle version of a 77mm ring:
And this a 67mm version:
The difference between the wide angle and the basic version is the thickness. The wide angle one is smaller in order to prevent vignetting on wide angle lenses.
c) The filters, well obviously:
The GND filters come in strengths from 1 to 3 stops in both hard and soft transitions. 4 stop filters are available as a special order. For anything stronger it’s recommended to use two filters together.
I’m using the Lee Filter System, which you also see here. Things might be a little different in different systems.
So, whether you get the Starter Kit or the Foundation Kit for the Lee Filter system you always will need an adaptor ring, suitable for the lens or lenses that you plan to use it with.
How does this come together?
Attaching the filter system is very easy. First you screw the adaptor ring to the lens:
Then you clip on the filter holder to the adaptor ring:
And finally you can slide in the filter(s):
This is basically all that you need in order to use them.
It is possible to upgrade this filter holder via the “Upgrade Kit”. Using that, you can use 4 filters together.
Are there other filters available?
The benefit of this filter system is, that you can also get all kinds of filters for it. There are Neutral Density filters available, warming filters, graduated colored filters, black and white filters and so on.
Also there are special Polarizer Filters available which can be attached to filter holder via an adaptor. I don’t have any of these yet, but I’m looking forward to expand my filter collection a bit in the future.
I think that’s it for this post. I hope it has shown clearly what is needed in order to use these filters. In the next post I will try to show some examples on how I used them of several of my images.
If you have any further questions or if something is wrong or unclear, you’re welcome to leave a comment.
Disclaimer: I’m not affiliated with Lee Filters in any way, I just use it and I hope everything I wrote here is correct. Just to make sure.